How To Repair A Plastic Key Case For Jeep Grand Cherokee
Time Required
5 - 10 minutes
- Cardinal Fob Battery 4 steps
Member-Contributed Guide
An awesome member of our community fabricated this guide. Information technology is not managed by iFixit staff.
Introduction
I developed problems with the FOB not functioning correct, needing to be close to the vehicle and in certain areas for it to work. Changing the battery was straight forward and restored its function immediately.
Parts
-
-
Hither is the FOB for my Jeep. Information technology decided to finally quit. The functionality became less over the last couple of weeks and required frequent attempts to unlock the vehicle etc.
-
Remove the key by moving
-
locking hatch to the left side showtime.
-
The two halves where the Play a trick on needs to be split are clearly visible
-
-
-
Using a plastic opening tool (or finger nail, guitar option etc.) start at the forepart of the Fox to separate it
-
Moving the tool forth the separate line with slight sideways pressure
-
will separate the FOB hands.
-
-
-
Here is the cleanly opened FOB
-
Bottom one-half of the FOB contains the CR2032 coin battery
-
Remove the battery past pulling it out of the holder pushing it gently against the spring contacts.
-
Replace the battery following the polarity with the positive side to the trunk of the FOB
-
-
-
Insert wisdom here.
-
Almost done!
To reassemble your device, follow these instructions in reverse society.
Conclusion
To reassemble your device, follow these instructions in contrary social club.
Team
0 Comments
Source: https://www.ifixit.com/Guide/2011+2012+2013+2014+Jeep+Grand+Cherokee+Key+Fob+Battery+Replacement/100781
Posted by: kleinyourbithes.blogspot.com
0 Response to "How To Repair A Plastic Key Case For Jeep Grand Cherokee"
Post a Comment